The '40' in the second line indicates that the LCD backlight is set to a hex value of 40 valid settings are from 00 through 80, thus 40 is at mid-range.The eight blocks of increasing height in the center of the second line are user defined characters, and can be changed.The '4' in the second line indicates that the length of a tab is set to four spaces valid settings are from 1 through 8 spaces.StickyNote 9.0 installation package is prepared to be downloaded from our fast download servers. All software that you can find here is freely downloadable and legal. The '4x20' indicates a four line by 20 character display other choices are 2X16, 2X20, 2X24, 2X40, and 4X16. Our collection also doesnt contain any keygens, because keygen programs are being used in illegal ways which we do not support. (Some PICAXE microcontrollers can operate at baud rates other than 2400, but 2400 is standard and is recommended.) The baud rate is hard coded in the LCD117 firmware, and cannot be readily changed by the end-user. The '2400' indicates the baud rate at which the device operates other possiblities are 4800, 9600, and 19,200 baud.The '117G' in the top left corner is the revision number of the firmware in the LCD117 adapter.You should probably not change the default settings until you gain some experience using the LCD117. Look at the boot screen picture above, and compare the boot screen display to defaults in the Control Command table. Note that the right-most column in the table shows the default settings that are in the LCD117 firmware when it ships from Modern Device.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |